This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
flink_example_1 [2015/03/28 08:14] – ursgraf | flink_example_1 [2015/03/28 08:17] – ursgraf | ||
---|---|---|---|
Line 116: | Line 116: | ||
Proceed as described in [[flink_vhdl|flink VHDL]]. | Proceed as described in [[flink_vhdl|flink VHDL]]. | ||
* In 5: add a block //gpio// and a block //pwm// to the system. Also add a // | * In 5: add a block //gpio// and a block //pwm// to the system. Also add a // | ||
- | * In 6: set the '' | + | * In 6: set the '' |
- | * After 10: the System | + | * After 10: the system |
* In 15: assign the pins as follows: | * In 15: assign the pins as follows: | ||
Line 163: | Line 163: | ||
|reset_reset_n|in|PIN_N9| | |reset_reset_n|in|PIN_N9| | ||
- | The pins for the PWM output and the GPIO have to be assigned according to your hardware. The FPGA can be loaded through the onboard PROM or through serial loading from the processor, see [[software:linux:emdebian:phycore-mpc5200b|Installation von Emdebian Grip auf den Phytec phyCORE-MPC5200B]]. | + | The pins for the PWM output and the GPIO have to be assigned according to your hardware. The FPGA can be loaded through the onboard PROM or through serial loading from the processor, see [[http:// |
==== Loading the kernel modules ==== | ==== Loading the kernel modules ==== | ||
- | Compile the Linux kernel modules ([[software: | + | Compile the Linux kernel modules ([[flink_linux|flink Linux Kernel Modules]]), transfer them to the target and load them with |
< | < | ||
insmod flink.ko | insmod flink.ko |