This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
flink_example_2 [2018/02/04 11:02] – [Setup FPGA Design] sfink | flink_example_2 [2019/12/12 20:09] – [Setup FPGA Design] ursgraf | ||
---|---|---|---|
Line 6: | Line 6: | ||
===== Setup FPGA Design ===== | ===== Setup FPGA Design ===== | ||
- | - Proceed | + | Start as described in [[flink_vhdl|flink VHDL]]. Follow below directions at the specific step. |
- | | + | |
- For subdevices add a pwmDevice, a gpioDevice and a infoDevice. | - For subdevices add a pwmDevice, a gpioDevice and a infoDevice. | ||
- Add default ports by right clicking on the pwm and gpios output port and selecting Create port. Just leave the standard values and press OK. | - Add default ports by right clicking on the pwm and gpios output port and selecting Create port. Just leave the standard values and press OK. | ||
Line 20: | Line 20: | ||
- | In the end the block diagram should look like this: | + | In the end the block diagram should look like this: \\ |
- | Instead of the " | + | (Instead of the " |
{{:: | {{:: |